Installation method of automatic soap dispenser

       1、Choose a suitable location, drill the bottom hole in the concrete wall with an impact drill and install the rubber plug. Then use the screws to fix the metal frame to the wall.

　　2、Fix the control box to the metal frame with screws, and then put the soap dispenser box on the metal frame. (Note: Please confirm the vertical distance between the soap dispenser nozzle and the bottom of the metal frame to avoid not dispensing liquid)

　　3, on the countertop to choose the right location, with impact drill a round hole (25mm diameter is appropriate), and then the faucet into, with nuts fastened. Installation should pay attention to the distance between the induction soap dispenser and the faucet to prevent malfunctions; the center of the round hole from the edge of the sink to ensure that the soap dispenser residue can drip into the sink.

　　4, the first clamp to the soap dispenser tube, and then the soap dispenser tube with a connector link to the conduit on the faucet, and finally clamped with a clamp.

　　5, the gear pump motor wire, induction head cable, power cord linked to the control box as shown. When linking the inductor cable, fasten it with a nut.

　　6, check whether the power supply is plugged in, please insert the adapter plug completely into the power outlet.

　　7、Please check whether the soap dispenser tube is completely linked and fastened.

　　8、Please check whether this wheel pump motor wire and induction head cable are completely linked and fastened.