News Center

hand soap dispenser does not foam what happened

time 2023-02-16

Daily life to develop a good habit of loving hand washing, such as going out and coming home to wash their hands, before and after meals should also wash their hands, so as to reduce the chance of accidentally contacting various bacteria and germs through their hands, so it is best to always have hand sanitizer at home, which can be absorbed at any time. The smart sensor hand sanitizer machine is seen in many homes, with it, when washing your hands, you only need to put your wet hands on the sensor area, you can automatically squeeze out the hand sanitizer, cleaning is very convenient. What is the fault of the smart hand sanitizer machine that does not produce foam?

A, intelligent induction hand soap dispenser does not foam what happened

1. Hand sanitizer is missing

When adding hand sanitizer in the hand sanitizer, pay attention to the outside of the hand sanitizer to add 10% of the water to remove the bottom of the hand sanitizer. Otherwise, if the hand sanitizer is not used for a long time, the hand sanitizer may be clogged.

2. Hand sanitizer is sticky

If the hand sanitizer is too sticky, it will make it impossible to press the hand sanitizer. You can dilute the hand sanitizer by injecting extra water outside the hand sanitizer.

 

A9302

 

3. Poor quality hand sanitizer

Poor quality hand sanitizer usually has a short life span and can cause many problems in the process of use. It is recommended to choose formal channels when buying and try to choose big brands with guaranteed quality.

4. Too much internal air

The main way of hand sanitizer is to press the liquid dispensing tube. If there is too much air inside the dispensing tube, it will be difficult to press the hand sanitizer. You can take out the pressure tube on the outside of the soap dispenser, then clean the excess hand soap to the outside, pour in water and press or use the soap dispenser to discharge the air inside the outlet tube.

5. Old broken pull spring

The pull spring in the hand sanitizer is used to support the pressure of the hand sanitizer in the hand sanitizer. If the pull spring in the hand sanitizer is old or broken, it will also cause the hand sanitizer to not be pressed out. It can be replaced with a new one.

+86 +86-0577-56901266

Interhasai@interhasa.com

GET A QUOTE

GET IN TOUCH NOW
×